I am having problems getting the Momentics debugger working properly. I have QNX6.3.2 rhapsody 7.4 and Momentics 4.0.1

The problem is that I can start a debug session and the program is downloaded to my target machine and runs, but the debug controls (pause, stop, start, etc) are greyed out and if the software stops due to a bug it does not load up the source code file and indicate where the problem is. If I mark a breakpoint it seems to stop at the breakpoint, but again there is no 'arrow' shown against the source code.

I had the system working with QNX 6.3.0 and rhapsody 7.2, but I had to install QNX6.3.2 and Rhapsody 7.4 alongside my existing setup. I haven't had to debug for a while and when I went back to do it, I had to reinstall the rhapsody-plug-in in momentics. And even though this plug-in is now there I cannot get a rhapsody-eclipse configutation to build in momentics, it seems to get all the include paths wrong. So at this point I am generting code in Rhapsody and then creating a standard C++ make project in Mometnics to manually build and test the code and this works OK.

it looks like the configuration has gone screwey somwhere. I've looked around all the settings and I cannot see anything obvious.

Hope somebody can help
Steve

I think you need to update your Momentics. QNX 6.4.1 uses 4.6 and that works with Rhapsody 7.5.1.

Basically Momentics 4.0.1 is built on a really old version of Eclipse and Rhapsody 7.4 supports Ganymede I think. QNX 6.3.2 should work with a newer Momentics.

I need to stick with Rhapsody 7.4 and QNX 6.3.2 to support current projects, but I will try the new Momentics IDE.

Thanks

Bit of a dumb question, but when I am in Rhapsody and create a new project in Momentics, what type of project should I choose and whatever type I try it does not seem to pick up the correct build info from rhrapsody.